Headphones Holder (Table Clamp)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An aesthetic way to store your headphones on the side of your desk!
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 155
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This convenient headphones holder is sure to help you store your headphones in an aesthetic, safe, and fast-to-print place!
Print Specs:
Time:
An Ender-3 could print this in roughly 2 hours (for both parts), so it's a speedy print!
Supports:
None! The 15mm hole may sag slightly at slower speeds (below 75mm/s) but should print fine on default settings for most machines!
Adhesion:
None! Whilst easy to remove, this print has a large enough surface area to have a convenient balance between ease of removal, and adhesion!
Speed:
As mentioned, low speeds can cause sagging, so take that into consideration. Ideally 100mm/s or over will work well.