Headphones Holder (Table Clamp)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An aesthetic way to store your headphones on the side of your desk!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 37
- Makes
- 0
- Views
- 155
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
This convenient headphones holder is sure to help you store your headphones in an aesthetic, safe, and fast-to-print place!
Print Specs:
Time:
An Ender-3 could print this in roughly 2 hours (for both parts), so it's a speedy print!
Supports:
None! The 15mm hole may sag slightly at slower speeds (below 75mm/s) but should print fine on default settings for most machines!
Adhesion:
None! Whilst easy to remove, this print has a large enough surface area to have a convenient balance between ease of removal, and adhesion!
Speed:
As mentioned, low speeds can cause sagging, so take that into consideration. Ideally 100mm/s or over will work well.