Blood pressure monitor hose connection repair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for broken hose connection of the automatic blood pressure monitor “Henry Schein” , Mod 9008181
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
EN:
Yesterday, the connection piece of the hose of the above-mentioned blood pressure measuring device broke off. A replacement was needed. Here is the result. It works.
Could be that it also fits other devices.
The inner diameter corresponds approximately to the original model. In the event that this is unstable in the future (as it was only made yesterday, it is not yet possible to carry out a long-term study), I have added a model with a slightly thicker outer wall and smaller inner diameter (V2). In my opinion, the different inner cross-sections should not influence the measurement result. I calibrated it with another device and tried both versions, but the measurement results were not significantly different.
Material: PLA / PETG
Layers: 0.3 mm / (0.2 mm)
Supports: Yes
QQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQQ
DE:
Gestern ist mir das Anschlussstück des Schlauches des oben genannten Blutdruck Messgerätes abgebrochen. Ersatz musste her. Hier das Ergebnis. Funktioniert.
Könnte sein, dass es auch bei anderen Geraeten passt.
Der Innendurchmesser entspricht etwa dem Originalmodell. Für den Fall dass dieses in der Zukunft instabil ist (nachdem erst gestern angefertigt ist die Angabe einer Langzeitstudie noch nicht möglich) habe ich noch ein Modell mit etwas stärkerer Außenwand und geringerem Innendurchmesser beigefügt (V2). Die unterschiedlichen Innenquerschnitte sollten das Messergebnis meines Erachtens nicht beeinflussen. Habe es mit weiterem Gerät geeicht, beide Versionen versucht, haben keine wesentlichen unterschiedlichen Messergebnisse gebracht.
Material: PLA / PETG
Schichten: 0.3 mm / (0.2 mm)
Stützen: Ja