ImpulseRC Apex Evo - Gemini Dual/Cross Band - 04 air unit - XT60 - Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount Designed to hold the dual antennas from the 04 air unit, both Gemini Cross band antenna, the xr4 Receiver + XT60
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 471
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I bought an overkill receiver and decided to find away to add it all onto my Apex Exo DC it will also fit the standard Apex Evo or most quads with 32mm rear standoffs.
To Print you only need supports on the very bottom, everything else prints fine.
To assemble, Install the XT60 First - you may need pilers to push this in from the underside - its a very tight squeeze.
Install Gemini Antenna, you will need to bend these to get them in or you could cut the print around the circular holes.
Install 04 antenna
Install XR4 receiver, with the bind button facing the bottom of the quad - There is a ledge for this to rest on which will prevent the bind button from being pressed during flight/crashes
Slide mount onto the Standoffs
Took loose wires into mount.
Yes, this is completely overkill - no, most people wont need it - yes, the antenna would be better front and rear or at an angle to each other but this works without having to run extensions to the front of the quad. I'm also not using it for stupid amounts of range, although ill still get that. I'm using this setup for noisy Environments, it suits my needs, it may suit someone else's.
