1 / 1
Bed belt clamp - Ender 3pro/v2/max series - 6mm/9mm/10mm belts — zdjęcie 1

Bed belt clamp - Ender 3pro/v2/max series - 6mm/9mm/10mm belts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This not meant for your stock belt, but in the event that you swap it to a fresh one. 6mm/9mm/10mm belts

Ocena
5 / 5
Polubienia
29
Pobrania
93
Wydruki
0
Wyświetlenia
432
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This not meant for your stock belt, but in the event that you swap it to a fresh one.

Print in PETG of better, no support needed

Supports ender3pro / 3v2 / 3max 3max neo beds

Disclaimer: After install there's a small chance that a belt tooth will jump in the S pattern around the bed belt cutout leading to a layer shift before it settles correctly, make sure to run a resonance test a couple times. or print something small with a bit of speed/accel to force the possible tooth jump as early as possible.
But ideally you should always run a resonance test after swapping belts/re-tensioning (I didn't do so, and had a layer shift after 1 hour of printing, I'm not 100% sure they were the cause, but it is my guess, after that it settled correctly, and have multiple hours worth of printing with no issues.).

M3x6 + heat inserts (m3 x 4mm L x 4.6mm or 5mm OD)

Regarding the screw length the added thickness is 4mm from what you had before.

if using stock wheels M5x34mm (or M5x35mm)

if using my linear rail setup (patreon), you would need M5x16mm

if using my linear rods setup (Patreon), you would need M5x34mm ~ M5x35mm


the difference is likely small, but for better precision best to have the belt through the bed belt cutout like stock belt was, see render.

 

------

Support me on Patreon !

https://patreon.com/squirrelf3d

or buy me a coffee
https://ko-fi.com/squirrelf3d
https://www.buymeacoffee.com/squirrelf

------

https://instagram.com/squirrelf3d/
https://twitter.com/squirrelf3d

Tagi