Knurled bolt for webcam mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to hold a Logitech C920 to my webcam mount (but useful for a lot of things).
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This was originally designed to be used with my webcam mount https://www.printables.com/model/1250262-neptune-4-webcam-mount-offset-for-logitech-c920 , as I didn't find any on Printables that were quite what I wanted.
It is a ¼-20 thread; 9mm, 12mm, and 15mm long. Standard thread size for camera mounts.
Note: I've updated these files to be at nominal width on the bolt (previous files had been adjusted for a printer that was overextruding – sorry about that!)
If you find these fit too tight, you can adjust in your slicer by scaling in X and Y (but NOT in Z!) by a few percent before slicing.