Magnetic Impossible Passthrough
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Impossible passthrough but with magnets which make it somewhat modular.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Share Alike
I found an impossible passthrough design that I enjoyed, but I figured there could be more enjoyment had. With that in mind, I thought of how cool it would be to have more impossible passthrough. That, coupled with my love of magnets, created an idea baby that resulted in this trial run of a modular impossible passthrough where one could add or remove parts of an impossible passthrough per one's fancy.
The top magnet holes on my first print were perfect to press fit some 4mm magnets (should be 4x2mm), but the bottom holes seemed to have expanded, leaving me with less fun than expected but more fun than deserved. I may go back and expand one set of the holes in order to allow for more freedom, otherwise any smaller size of magnet should fit fine with some super glue or the sort.
If you are not interested in magnets (your loss) then feel free to just check out the original design here and be sure to spread the love or whatever:
https://www.printables.com/model/1022866-impossible-passthrough-starter-pack