1 / 2
AR Wall Mount fits Tactical WMW rifle wall mount — zdjęcie 1
1 / 2

AR Wall Mount fits Tactical WMW rifle wall mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Use at your own risk!

Ocena
0 / 5
Polubienia
1
Pobrania
25
Wydruki
0
Wyświetlenia
270
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Remixed from someone on Thingiverse. It was the V1, as I didn't see the V2 or others at the time. It still works well for me.

*** I did have an issue with the spacing of the support for the bed side screw lugs I believe, because they are above the bed a little, as the model had chamfered rear edges before I added the screw lugs. This caused some slightly ‘loose’ print filament along the start of the lower gusset of this model. It still works fine, and seems strong but if you want it to look and be better, it may be something to note/change. ***

Made to fit a certain * tactical * company's * walls * system, with random screws of your choice that fit. I like to heat the screws lightly before screwing them in, so they'll easily self-thread. Be careful not to over-heat. 
This is not made, affiliated or designed by the above mentioned company.

 

I printed with Creality PETG at 85C/265C throughout 

25mm/sec .12 first layer

250-270mm/sec .2 all subsequent layers, slow for overhangs

Either 25% or 30% infill (you can always add more if you want)

3 top shells, 3 bottom shells, 2 wall loops

Print flat on gusset side, supports for mounting lugs, might need to edit lowest bed side lugs/supports.