AR Wall Mount fits Tactical WMW rifle wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use at your own risk!
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 25
- Makes
- 0
- Views
- 270
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
Remixed from someone on Thingiverse. It was the V1, as I didn't see the V2 or others at the time. It still works well for me.
*** I did have an issue with the spacing of the support for the bed side screw lugs I believe, because they are above the bed a little, as the model had chamfered rear edges before I added the screw lugs. This caused some slightly ‘loose’ print filament along the start of the lower gusset of this model. It still works fine, and seems strong but if you want it to look and be better, it may be something to note/change. ***
Made to fit a certain * tactical * company's * walls * system, with random screws of your choice that fit. I like to heat the screws lightly before screwing them in, so they'll easily self-thread. Be careful not to over-heat.
This is not made, affiliated or designed by the above mentioned company.
I printed with Creality PETG at 85C/265C throughout
25mm/sec .12 first layer
250-270mm/sec .2 all subsequent layers, slow for overhangs
Either 25% or 30% infill (you can always add more if you want)
3 top shells, 3 bottom shells, 2 wall loops
Print flat on gusset side, supports for mounting lugs, might need to edit lowest bed side lugs/supports.