Idler Pulley Steel Replacement Forbidden V1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses steel 16t SRAM EX1 chainring and stock Forbidden hardware. Fits V1 Druid and Dreadnought.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Use at your own risk, this is a prototype. It will not hold up to long term use. I did get more miles than I expected out of mine, but unless you print it out of an exotic engineering filament or modify the design to work for metal, this isn’t a permanent replacement for the original part.
Works with Druid V1 and Dreadnought V1.Print 100% infill, preferably with an engineering filament. Pictures are printed with PETG-CF, a 0.6mm nozzle, and a 0.3mm layer height. Print inside down, classic supports. Support accuracy is important for bearing fitment.
Parts you'll need:
-6902 bearing(same as the original).
-Sram EX1 16t chainring. X-SYNC Chainrings for Bosch | CR-XSNC-BOS-A1 | SRAM Sram part 00.6218.007.001
-4x M3x6 countersunk screws. I recommend stainless steel.
-4x M3*3*4.2 heat set inserts set from the back.