1 / 1
Qidi Plus4 Hinged Monitor Housing
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a monitor shell that is hinged and replaces the original monitor shell, it also raises the monitor 25mm
- Ocena
- 3,5 / 5
- Polubienia
- 19
- Pobrania
- 111
- Wydruki
- 1
- Wyświetlenia
- 635
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (42)Powiązane
(Excuse my print quality on my sample image, I was experimenting with a new filament.)
This is a monitor housing for the Qidi Plus 4 that replaces the original housing. it does a few things:
- Adds a hinge so that you can adjust the angle of the monitor
- Seals the open holes better to prevent heat from escaping when the hinge is in its closed position
- Raises the monitor by about 25mm to clear risers,
- The raised monitor also provides space around the door frame for the permanent door seal (coming soon) which is the original reason for why I created this.
Print recommendations
- I optimized the back to reduce as many supports as possible: Print the back piece standing up on it's bottom edge, and use paint on supports on the bottoms of the hooks, the bottom of the opening for the plug into the back of the monitor, and a few millimeters into the edges of all the hinge openings (all 4 openings).
- The front piece is not as important for the direction but I had success printing the top piece, the monitor holding piece, on it's side standing up. Use supports on the hinge and the opening for the cord, as well as the shell space holding the monitor, including the smaller lip.
- Avoid using a filament that is prone to warping like ABS unless you have a lot of experience keeping it under control; the shell for the monitor is a tight fit.
To remove the monitor from the original housing
- Be extra careful and do NOT pry it, it's very fragile
- Heat it up and push it out from the opening where the plug is.
- I heated mine by just having a long print with the chamber heater on, while the monitor was in its stock position, the machine will create enough ambient heat to loosen up the glue and you can just push it out with very little force, I do not recommend forcing it out, the screen can crack.
- You don't need to replace the glue if you keep it clean.
Assembly and materials:
- 2 @ m3x25 screws, these serve as the hinge pins, I recommend a course thread due to layer directions, and the friction required for keeping the hinges open.
- The tighter you thread the screws, the tighter the friction of the hinges.
- slide the cord in to the channel between the hooks so that it has enough space to for the hooks to seat.
As always, use at your own risk!
and I always provide the step so you can mess with it yourself.