1 / 4
Updated VzBot 3010 Fan Mount for Magneto Filament Cutter — zdjęcie 1
1 / 4

Updated VzBot 3010 Fan Mount for Magneto Filament Cutter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Upsized the air cooling from 2510 to 3010 fan

Ocena
5 / 5
Polubienia
35
Pobrania
195
Wydruki
1
Wyświetlenia
672
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Feedback is welcomed in the comments.  I am personally running the v3 version and it is working very well so far.  With the 2510 duct from Github, I was getting some occasional clogs but not anymore.

I recommend printing it top down with a brim.  You may also need to reduce your accels to prevent the print from getting knocked off the plate.   And also it's best to use ABS, ASA, or PC for high-temp resistance.

Needs (4x) four M3x14 screws to attach your fan to it.

Please post your makes & comments!

Update 4/3/2025 - In the v1 file, I noticed that the area for the screw heads was not large enough, particularly if you wanted to use a washer.  So I came up with version 2 which I think also has a little better air flow and smoother lines.  Both versions are available in the files section.

Update 8/22/2025 - Realized that the back half that grips the cooling fins on the Goliath was a bit to tall.  I reworked it to resolve that issue and also fine tuned the air flow path just a bit.

Tagi