1 / 2
120mm fan mount for BTT Manta M8P — zdjęcie 1
1 / 2

120mm fan mount for BTT Manta M8P

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount a 120mm computer fan above Bigtree Tech Manta M8P board.

Ocena
4,8 / 5
Polubienia
37
Pobrania
216
Wydruki
4
Wyświetlenia
829
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

BOM:

  • 4 of threaded inserts (Voron standard M3x5x4).
  • 4 of 30mm SHCS to attach the mount and the Manta board.
  • 4 of whatever length M3 screws you need to mount your fan. I used 25mm SHCS.

Print instructions:

  • Set “Bridge counterbore holes” to “Partially bridged", and enable “Convert Holes to Polyholes” in Orca Slicer (because the long holes have very small clearances, else you may need to ream them out).

Technically, this is a clean redesign, not a remix - I did not use the original model, as the author did not share any CAD files. But the result is similar.

I addressed these changes:

  • Instead of attaching the fan from the underneath of the mount, the fan is now attached by screws going into threaded inserts. This makes it easy to remove the fan and do some work on the board, as opposed to removing the whole mount, and thus detaching the board itself, too.
  • My printer has 7 steppers, and I found that the fan position was suboptimal for me, because the seventh stepper driver was not in the airflow of the fan.
  • My mount does not put any parts in front of the fan blades, there is a large round opening larger than the diameter of the fan.

I'm uploading a Fusion 360 file if you want to modify this some more. The Parameters table has some likely variables for you to modify, like the fan offset from the side and from the bottom (if you want to change the position of the fan) and the clearance below the mount (if you want to raise or lower it).

Tagi