Commodore 64 Key Stem

This is just the stem for a key from a Commodore 64 keyboard.  It does have a fair bit of detail to it, probably best for resin printing… Dimensional accuracy is important for a good fit.

I did a number of prototypes on my FDM printer and got some decent results, but I had to fiddle with the settings a bit, and when I finally got a good one that stuck solidly, the layers separated trying to remove it, so…  Would not recommend FDM in PLA for sure.

Have seen other decent options out there, but didn't find them until after I'd gone pretty far down this rabbit hole, so I figured I'd finish what I had and upload it anyway.

Would love it if someone would print one in a hard resin just to see if it can be a good replacement.