btt eddy probe stealthburner side mount for TZ ver2 ver3 and revo

tested using TZver3, working well.

According to the CAD drawing, Revo hotend should work too.

using this mount, the eddy probe has distance to nozzle tip about 1.8 to 2mm.

it's just right height.

The printer will lose about 9mm on X size, no impact on Y.

How to mount: using the two screw holes with heat insert on stealthburner left.

suggest use 2X button head M3 X6mm to mount this part on sb side.  button head has smaller lower height so it won't block eddy body. (every mm is critical so we won't lose more X/Y print range)

use two 18mm or 20mm self tapping screw to mount eddy probe on this part.

if you want to , you can even use solder iron to push the screw head into eddy's plastic body.

the upper part of the eddy body is all empty.

suggest reudce X max size by 10mm and slowly adjust it to find the best value, so eddy won't crash on the edge and the print size is not impacted too much.

you have to change the MAX X and some other data from config.

Eddy Offset to nozzle tip:   X: 30.65  , Y: 15.73  ,   Z:1.9 for revo  about 2mm for TZ ver3 

note, do not let eddy probe at outside of the bed, your nozzle will hit hard on the bed, specially doing QGL. Give it large X probe point ie 50+ and look and adjust if wish.

If you set QGL probe point too small, ie x=20, eddy will be outside of bed because it's on left of nozzle offset 30.65, it will never trigger the eddy probe so nozzle hits the bed.

When first time working setting up eddy, suggest reduce Z Z1 Z2 Z3 and X Y stepper motor current, so even if things go wrong, your nozzle hits the bed,  you won't lose your nozzle and bed or worse.

note, you don't need to mount the eddy probe on the side, unless there is a very special reason.

In my opinion, eddy should be mounted in the old inductive probe place.

Eddy has it's own hardcoded data to detect distance from bed, it has nothing to do with how you home Z and how your Zendstop check the bed and how you adjust z-offset. None of these can change how eddy print on what height from bed. Again, It's hardcoded from the data it does the paper calibration : PROBE_EDDY_CURRENT_CALIBRATE_AUTO CHIP=btt_eddy
 

So, for example, do not expect using a Klicky probe to get an accurate z offset and use eddy to do bed mesh and print better, it won't work. besides, klicky cannot work with btt eddy , not without a lot of marco enhancement and modification…which I already did and I learned it the hard way klicky won't help eddy. only eddy can help eddy to adjust the print height.

step source file provided, feel free to adjust if needed.