MagTag case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the MagTag that I'm using for my MagTag ISS Tracker project.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 274
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
Case for my MagTag ISS Tracker project. CircuitPython source can be found at https://github.com/apendley/magtag-iss-tracker.
I printed both pieces face-down with no supports, using 15% infill. I used Polymaker Pro silver filament for a retro space-agey prototype feel.
Fasten the front cover to the MagTag with 4 M3x6mm screws. I used black nylon screws for aesthetic reasons, but any type of screws will do.
For assembling the back cover, there are three options:
- Fasten back cover to MagTag with 4 M3x6mm screws for a free-standing build
- Fasten back cover to MagTag with magnetic feet to enable mounting on metal surfaces, such as refrigerators, etc.
- Fasten back cover to MagTag along with Skadis hooks from https://www.printables.com/model/86615-magtag-support-on-skadis using M3x10mm screws to enable mounting on Ikea Skadis peg boards.
TIP: If using a lighter colored filament, to prevent light bleed from the LEDs through the front cover, put some black masking/gaffers/electrical tape on the inside of the cover right above where the LEDs on the MagTag are positioned when mounted.
