1 / 3
IKEA KALAS glass planter self watering pot with drainage holes — zdjęcie 1
1 / 3

IKEA KALAS glass planter self watering pot with drainage holes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Turn the IKEA KALAS plastic glass into small planter/ starter self watering pot

Ocena
0 / 5
Polubienia
2
Pobrania
10
Wydruki
1
Wyświetlenia
120
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Easy print to turn IKEA KALAS plastic glass into small planter/ starter self watering pot. Spring has sprung, and it's time to prepare your plants for the garden. I designed this self-watering pot using glass cups from IKEA and was amazed with the result, so I designed a smaller version for plastic cups since I had plenty of them laying around. 

In my experience, the water will drain quickly in the first few days while the shoot emerges from the soil, then water consumption will reduce.

Recommendation: Moisten the dry soil with a spray after planting your seeds, to help the plant while the water begins to rise in the pot. 

I don't recommend using this pot for long term use, you should replant in a bigger pot once the plant has grown.

2025-09-05 Added 4 small holes to get rid of soil excess of water. Warning: please don't put plant that will rot if too much water/constant water soil. 

Additional materials

  • KALAS tumbler/ plastic glass (004.613.79) 
  • Macrame Cotton Cord 5mm thickness - example 

Special tool

Installation 

  1. Remove support/ post processing 
  2. Use the punch to insert the cord into the hole upward in the pot (see the picture) and use the plier to pull the cord inwards - the hole is intentionally small compared to the cord, this is to retain the water more easily 
  3. Make a knot
  4. Pull back the cord to make the knot flush to the bottom of the pot
  5. Cut the cord at the right length so that the cord drags a little at the bottom of the KALAS plastic glass, but not too much - around 7cm
     

Print instructions

  • Material: PETG (helps retain water) 
  • Top/bottom surface pattern: concentric (reduce printing time a lot)
  • Wall: minimum 3 (helps retain water) 
  • Infill: 15% (but not really needed since the walls are small)
  • Supports: use (tree) support for the edges

Tagi