1 / 52
Prusa XL Nozzle Wiper (with detachable waste compartment) — zdjęcie 1
1 / 52

Prusa XL Nozzle Wiper (with detachable waste compartment)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Prusa XL Nozzle Wiper (with detachable waste compartment and magnet attachment)

Ocena
5 / 5
Polubienia
71
Pobrania
200
Wydruki
8
Wyświetlenia
1259
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Prusa XL Nozzle Wiper (with detachable waste compartment)

Prusa XL nozzle wipe inspired by the models listed below:

https://www.printables.com/model/678703-prusa-xl-tool-change-wiper-brush/files

https://www.printables.com/model/1165279-prusa-xl-nozzle-wiper

https://www.printables.com/model/821255-remixed-prusa-xl-tool-change-wiper-brush-floating

Remade from scratch to include detachable waste compartment (with or without magnets) and areas around the brush for debris to fall through 

Uses half of a silicon brush of a bambo lab a1 mini or any brush of similar size (these were the cheapest easiest brushes I could find) 

Example Si brush here:

https://www.amazon.com/dp/B0DHDCZD8G?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 

Just cut them in half and they should work

Magnet version

There is a magnet insert version of the .stl 

Please use 6mmx2mm magnets if printing this design

Example Magnet here:

https://www.amazon.com/dp/B09XK9ZMVQ?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

If using magnets you will need to pause in 2 sections to insert the magnets and continue with the print

I used a small amount a glue during the pause, but most likely not needed

Note: Remember to insert the magnets in the same direction to keep the polarity the same

No Magnets

The no magnet version will fill the areas where the magnet would go and requires no pauses

-------------------------------------------------------------------------------------------------------

I printed mine using PETG with magnets and it seem to work well - .4mm nozzle, layer height .2mm, print both top and bottom sections at once

  • No supports needed
  • Recommended PETG
  • Two versions (with magnet inserts, and without)
  • M3 or M4 10mm screws will work to attach to the back AL rod - I ended up using the filament holder M4nEs with a 10mm M4 to attach them in place

Enjoy!

 

 

 

 

 

Tagi