Hook for Modular Shelving or Desk

Hook to attack to modular shelving unit upright. Not sure the exact standard of the “slotted standard” but the holes are 1" on center with a tapered trapezoidal cut with the narrow end being about .485" and the wide end at the top being a little over 1/2". I needed a place to hang my headset at the, but also figured i could use it for various other cords and cables to keep them up out of the way. The thickness of the uprights was about 0.11". It is not fancy, but for the units we had, they snapped right in and were plenty sturdy for light objects.

Print on its side so that you dont have layer lines cutting across the cross section of the locking tabs. That is where it will break. I printed in 0.2mm layer height with 3 perimeters, that seems to have worked out alright. I recommend PETG, I think that helps to facilitate a better fitment with the steel and allow it to deform itself into place. I used Prusament, Ocean Blue in the pictures but am sure other filament would work.