1 / 3
HP G5 USB-C Dock and Power Supply Under Table Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Does not block any air vent or port. No support needed, PLA worked fine, 52.15 grams of filament, 3h3m on Prusa MK4
- Ocena
- 4,75 / 5
- Polubienia
- 15
- Pobrania
- 245
- Wydruki
- 4
- Wyświetlenia
- 645
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 4) (Komentarze: 7)Remiksy (0)Kolekcje (26)Powiązane
I created this to clean up a conference room installation, the dock used to sit on the table and it looked better under the table with only the usb-c cable on the table. The dock does not block an air vents, buttons, or ports. It can be printed with no supports (assuming your printer can handle a 45* slant). I used PLA and PETG both printed fine and hold dock and power supply fine. MK4 took 3 hours and 3 min to print, dock height should be 45mm