1 / 3
HP G5 USB-C Dock and Power Supply Under Table Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Does not block any air vent or port. No support needed, PLA worked fine, 52.15 grams of filament, 3h3m on Prusa MK4
- Rating
- 4.75 / 5
- Likes
- 15
- Downloads
- 248
- Makes
- 4
- Views
- 652
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
I created this to clean up a conference room installation, the dock used to sit on the table and it looked better under the table with only the usb-c cable on the table. The dock does not block an air vents, buttons, or ports. It can be printed with no supports (assuming your printer can handle a 45* slant). I used PLA and PETG both printed fine and hold dock and power supply fine. MK4 took 3 hours and 3 min to print, dock height should be 45mm