1 / 7
Bowden Tube-to-Tube Connector -- Fully 3D Printed! — zdjęcie 1
1 / 7

Bowden Tube-to-Tube Connector -- Fully 3D Printed!

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Connect up your filament paths with solid, low-profile, easily printed couplers!

Ocena
5 / 5
Polubienia
17
Pobrania
107
Wydruki
1
Wyświetlenia
451
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Print Settings

Normal print setting should be fine with layer heights of 0.2mm or lower. The Coupler has built-in bridges that remove the need for any supports or counterbore bridging. You may want to try printing the Collets slowly with low fans, these parts need to flex and reflex so getting strong layer adhesion is imperative. All parts should be printed in a strong filament like PETG or ABS/ASA.

 

Parts to print

You will need to print 1 Coupler, 2 Cuffs, and 2 Collets for each Connector. 

 

Assembly

To assemble, press the Collets into either end of the Coupler. Insert the Bowden tube before sliding the Cuff into place.

 

Tips

Once the Tube is in the Collet, it's easy to pull up the first ~1.8mm with the Tube. Just make sure you give the Tube a good shove back in before installing the cuff (to minimize the gap).

I found through my experimentation that even if one of the arms breaks part way, but stays connected to the base, the Collet can still be used, as long as all the arms still move together.

 

How does it work

As the Collet is pulled up, it interacts with geometry inside of the Coupler, reducing the inside diameter to just under the tube's outer diameter, firmly securing it in place. Once the the 2mm Cuff is inserted, the Collet is locked in place and the tube won't move until you remove the Cuff again. Then, simply pressing the Collet back into the Coupler releases the tube.

 

Why did I make this?

I wanted a way to quickly and easily connect and disconnect my filament dryer and my usual filament path. I thought about using metallic Bowden connectors, threaded into a printed part, but the added weight and the required hardware struck me as a non-starter. After having it roll around in my head for about a week, I landed on this idea.

If you have any notes on how this might work better, I have included the .STEP file and remixes are always welcome.

 

Let me know what you think and please consider posting a make when you're done!

Happy Printing!

Tagi