Ninja 400 - Dashboard mount for race fairings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print allows you to mount your dash directly to a race fairing stay without use of the stock bodywork
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 287
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
To save weight for a Ninja 400 race bike, it is common to replace the heavy stock fairing stay with an aftermarket one, such as the Motoholders race fairing stay. If you do this, you need to reuse cumbersome stock bodywork to mount the dash or you can use this design to eliminate all the stock plastic and save weight!
I have not tested this with any other brands of fairing stays.
This design requires M5 heat inserts which can be installed with a soldering iron. I highly recommend using special tips designed for this purpose. This design is modeled to use these M5 inserts but should work reasonably well with other sources.
It also requires two 20-25mm M5 bolts and some oversized washers to secure to the stay.
I have run a PETG print of this design for a full California race season and the only time I've had to replace it has been due to crash breakage. It is likely to heat creep eventually, so if you have the ability to print with ABS you'll get much more life from it.