Crew Boat Part Collection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Various rowing boat parts I have designed over the years in an attempt to help fix up boats cheaper and easier.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
One of the most frustrating challenges of being on a rowing team is dealing with equipment failure. Parts can be expensive, hard to source, and often proprietary, meaning you're forced to buy replacements from specific manufacturers. Unsurprisingly, this didn't sit well with my engineering mindset, so I set out to address the issue.
(NOTE: The skegs should only be used for reference at this time as they has not been tested).
I've included the .step files in hopes that others can take these parts and adjust them to their own needs. Be aware that these parts are unfortunately very boat dependent and thus will almost definitely need adjusting based on your setup.
Be sure to check my profile for a collection I've built of other user's boat parts and designs!
Updates:
2/20/26: Added a model for a Hudson 8+ skeg, Sykes track cap, and an extended speed coach arm
4/25/25: Found the bow card holder to be too loose for actual use and redesigned for tighter fit.
4/29/25: Vespoli Seat Carriage failed after 3 uses. However, carriage was used without central aluminum bracing rods. Redesigned to feature 2x thick central wall for increased strength, fixed issue where entire object was 3mm too tall, and added missing fillets. Plan to reprint with ASA and test further.