UBBI connectors for the Ultimate Cereal Container Filament Drybox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For those that are fans of the UBBI connector... This is the best topping for your morning cereal.😎
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 328
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This replaced the PC4-M10 Bowden couplers with UBBI connectors. I have included an updated jig that has two key slots which will help you keep the connector vertically aligned.
Printing:
- 0.2 layer height. For the UBBI I prefer to use 0.12
- Infill is your choice
- PETG or stronger
The UBBI parts are laid down on their sides. This is important as the support for the UBBI is already present. If you attempt to replace the supports then your connector may not print out correctly. For any other overhanging part like the handle or the filament channel, you should paint on a support for that area.
Installation:
- Use the jig to mark where you will drill the hole (10mm or 3/8 drill)
- Note the two key marks on the jig, use a sharp pen knife to cut out the same on the cereal box, they can be slightly undersized to keep it snug and prevent any spinning of the connector.
- Find the triangle marked on the tops of UBBI and the connector nut. Press the UBBI from the outside through the box, then align the triangle on the nut to point to the triangle on the UBBI and press-fit it together. It should bottom out against the inside of the box and not wiggle free.
- Use the new coupler cap to keep the filament from drying out and to have it handy to pull through.
You can use the same tag and hydrometer holders from the original.