Ikea Moppe drawer handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Can't fit your finger into your IKEA MOPPE drawer? Add a handle!
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My very old IKEA MOPPE drawers recently got a gridfinity upgrade. While we have 38mm spare room to the sides, in depth it only has a few mm spare. After I printed my first complete drawer of boxes I figured out, that I could no longer open the drawer by sticking the finger into the designated hole…
So I designed a handle to be inserted into the grip hole as an alternative way to open the drawer. It is quite a snug fit and prints without supports (in PETG anyway, because I had that at hand. PLA would be fine most likely as well…). There might be some sag on the overhangs at the front lip and at the front portions edge, but those do not hurt, as the prior improves grip on tugging and the latter improves the snuggness (?!) of the fit.
It's a perfect fit on the very old drawers. My wife has more modern MOPPE boxes and there it's little hit&miss regarding the height. Some fit perfectly, others don't, so there you might need to shave off 1-2mm on either the box or the handle.