1 / 5
Simple 2-part Lid Latch (friction hasp) by Design8Studio — zdjęcie 1
1 / 5

Simple 2-part Lid Latch (friction hasp) by Design8Studio

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple 2-part Lid Latch (friction hasp) by Design8Studio

Ocena
0 / 5
Polubienia
11
Pobrania
37
Wydruki
0
Wyświetlenia
381
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Latch (friction hasp) by Design8Studio. This was designed for use on a lid that is listed as ‘nominal’ ½" thickness, which actually measured 11.78 mm thick. Can be used on thinner lids by moving the lower “catch” part further down from the lip (from the top edge of the side). To use on thicker lids, may require either scaling up in slicer, or possibly remixing.

Suggested printing tips:

  • Print in PLA
  • 0.4 mm nozzle
  • 0.2 mm layer height
  • Perimeter walls: 3
  • No supports required
  • Infill: suggest 30%

Also check out these related printable hinges:

Simple Hinge by Design8Studio - for using PLA (1.75mm) as the hinge pin

https://www.printables.com/model/1260463-simple-hinge-by-design8studio-for-using-pla-175mm 

Simple Hinge by Design8Studio - for 2mm coat hanger wire as the hinge pin

https://www.printables.com/model/1260466-simple-hinge-by-design8studio-for-using-2mm-coat-h