1 / 5
Simple 2-part Lid Latch (friction hasp) by Design8Studio — image 1
1 / 5

Simple 2-part Lid Latch (friction hasp) by Design8Studio

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple 2-part Lid Latch (friction hasp) by Design8Studio

Rating
0 / 5
Likes
11
Downloads
37
Makes
0
Views
381
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

Latch (friction hasp) by Design8Studio. This was designed for use on a lid that is listed as ‘nominal’ ½" thickness, which actually measured 11.78 mm thick. Can be used on thinner lids by moving the lower “catch” part further down from the lip (from the top edge of the side). To use on thicker lids, may require either scaling up in slicer, or possibly remixing.

Suggested printing tips:

  • Print in PLA
  • 0.4 mm nozzle
  • 0.2 mm layer height
  • Perimeter walls: 3
  • No supports required
  • Infill: suggest 30%

Also check out these related printable hinges:

Simple Hinge by Design8Studio - for using PLA (1.75mm) as the hinge pin

https://www.printables.com/model/1260463-simple-hinge-by-design8studio-for-using-pla-175mm 

Simple Hinge by Design8Studio - for 2mm coat hanger wire as the hinge pin

https://www.printables.com/model/1260466-simple-hinge-by-design8studio-for-using-2mm-coat-h