1 / 8
Budddy3D camera for prusa XL enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new housing for the buddy3D camera made to fit inside of the prusa XL enclosure
- Ocena
- 4,5 / 5
- Polubienia
- 27
- Pobrania
- 56
- Wydruki
- 1
- Wyświetlenia
- 478
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (41)Powiązane
A housing to perfectly fit the internals of the buddy3d camera into the prusa xl with an enclosure. The camera is mounted using magnets.
Recommended material: PETG
Recommended orientation see picture →
There is some assembly required in the following steps:
- Dismantle the buddy3D camera. To make disassembly easier you can disconnect the motor cables and the power cable between the USB C PCB and the main board. Do not disconnect any of the other wires!
- Glue the four magnets into the first printed part. (Magnet size can be a maximum of 10x3 mm)
- Assemble the camera internals into the second printed part as shown in the picture. The screws taken out of the buddy camera can be reused in the new housing.
- Mount the two printed parts together with a single M3*16 bolt and M3 nut.
- The camera is now ready for installation.
- Use a two meter USB C cable to reach the back of the printer and use the tie wrap holes to mount the cable along the sides
Now your setup is complete. Enjoy!
Updates:
Added extra holes to clear obstructions from the enclosure