Logitech K800 Inner Key clip/hinge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement inner clip for Logitech K800 keyboard.Best printed by PLA; PETG is slightly worse. I printed it on Prusa…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacement inner clip for Logitech K800 keyboard.
Best printed by PLA; PETG is slightly worse. I printed it on Prusa mk2 FDM printer with 0.4mm nozzle, but it requires a lot of postprocessing with a knife, especially the lower part. It would be much better with 0.2mm nozzle, unfortunately I don't have one and I was in a hurry to fix my keyboard. SLA would be probably best option. Use the smallest layer height as possible, I used 0.1mm.
It's quite difficult to print because of small pins, I used support without any contact distance and then I removed the supports with a knife. It might be better with a smaller nozzle, I'll see when another key will break. Definitely you need to adjust it a little bit by small knife. I didn't do any more postprocessing.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
Yes
0.1mm
Infill:
100%
You need to do fine adjustments with a knife.
Category: Parts