Foxeer Micro Lollipop Mount for Meteor75 Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Foxeer Micro Lollipop FPV Antenna Mount for Meteor75 Tiny Whoop Frame
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a mount to fit a Foxeer Micro Lollipop Antenna to the Betaflight Meteor75 frame (NOT 75 pro!).
Just print it in TPU (I used 95A TPU from Overture), without supports the slicer might bicker about floating regions, but that's OK. My A1 Mini handled it quite fine and I only had to clean out 2-3 loose strands of TPU on the bottom side for a snug fit. First slide in the antenna, then hook the mount into the slots on the back of the frame. No Hardware needed. If you need to remove the antenna from the mount, you can push some filament or something of similar diameter into the honeycomb mesh on the rear side of the antenna cap. There is a small lip on the lower edge to prevent slipping during crashes.
For me (AIO FC from a Mobula7) it worked just fine so that the antenna cable had a slight bend around the rear canopy screw.
The Antenna is angled at 40°, because I usually fly at 30, but when I angled it up to 60° I had to either bend the cable in a sharp edge or I'd get too high for my whoop case. 40° (which would correlate to a 50° camera angle for optimal range) feels like a nice compromise, given that you most likely won't long-range this setup…