Monitor Arm Planter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Planter for top of monitor arm
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution
A pretty simple pot for my monitor arm, currently fits a 4" plant perfectly. Might update later with a 6" version but that would look kind of funny so I might not.
Slots right onto the monitor arm swivel for up/down which was about a 1" width so that's what the gap is. Guaranteed* fit for Huanuo dual monitor arm (the most popular one and cheapest on Amazon atm4/25)
Print/Supports
I printed at the exact layout of the desk photo, small supports painted on the floating stem, some on the bottom as well just to build material, and a brim.
15% infill is fine, I used a carbon PLA and printed on a K1c. Took about 5.5 hours to print, use glue because there is not a lot of sqft for the print to stick to.