1 / 2
Simagic Maglink Fanatec QR2 Drilling Template
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A template to drill the Simagic Maglink to mount the Fanatec QR2
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 274
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Maybe this helps you to break free from the Fanatec Eco System.
For everyone who is afraid to weaken the Maglink: In engineering we are regarding minimal hole distances. Hole distances of 2,4 x dia of the hole is an acceptable minimal hole distance at which each hole can carry its full load.
After drilling the distance between the holes is at least 3 x dia (5,1mm), which is the regular hole distance according to EUROCODE9.
So drill on!
- Screw the template to your Simagic Maglink. Pay attention to the orientation during installation. CABLE goes where the MagLink Cable is, TOP points away from the MagLink Cable.
- Drill the QR2 holes through the template, take care not to damage the cable.
- Disassemble the template from Maglink.
- Countersink the QR2 holes from the same direction as the already existing holes.
- Assemble the Simagic Maglink to your QR2.
- Assemble the Simagic Maglink to your Simagic Wheel.
- Go Racing!