1 / 2
Jabra Elite 65T TPU cover - "Hinge Fix" — zdjęcie 1
1 / 2

Jabra Elite 65T TPU cover - "Hinge Fix"

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a slip cover I designed for my Jabra Elite 65T. It fits tightly around the original case.

Ocena
0 / 5
Polubienia
7
Pobrania
40
Wydruki
0
Wyświetlenia
207
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a cover I designed for my Jabra Elite 65T after the original case's hinge broke. It keeps the top and bottom halves of the case connected and allows opening and closing just like the original hinge. It also has an opening for the charge port and the charging status LED. It fits tightly enough that no glue is required.

 

Print it out of flexible TPU filament, with supports enabled and the opening oriented flat against the build plate. You should make sure your support settings are dialed in appropriately for TPU to avoid headaches removing the supports later. The settings you use with other filaments might meed adjustment.

 

Fresh out of the printer, the case will spring open. If you want it to spring closed instead, after fitting it onto the case, hold it tightly closed with one hand and with the other hand use a heat gun or mini torch to GENTLY heat and re-set the hinge. You don't want to melt the hinge TPU, just get it warm enough to soften and then cool again so it adopts the new position. 

Tagi