1 / 2
Jabra Elite 65T TPU cover - "Hinge Fix" — image 1
1 / 2

Jabra Elite 65T TPU cover - "Hinge Fix"

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a slip cover I designed for my Jabra Elite 65T. It fits tightly around the original case.

Rating
0 / 5
Likes
7
Downloads
40
Makes
0
Views
207
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

This is a cover I designed for my Jabra Elite 65T after the original case's hinge broke. It keeps the top and bottom halves of the case connected and allows opening and closing just like the original hinge. It also has an opening for the charge port and the charging status LED. It fits tightly enough that no glue is required.

 

Print it out of flexible TPU filament, with supports enabled and the opening oriented flat against the build plate. You should make sure your support settings are dialed in appropriately for TPU to avoid headaches removing the supports later. The settings you use with other filaments might meed adjustment.

 

Fresh out of the printer, the case will spring open. If you want it to spring closed instead, after fitting it onto the case, hold it tightly closed with one hand and with the other hand use a heat gun or mini torch to GENTLY heat and re-set the hinge. You don't want to melt the hinge TPU, just get it warm enough to soften and then cool again so it adopts the new position. 

Tags