Sovol SV08 92mm Mainboard Fan Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to mount a 92mm fan for cooling the SV08 Mainboard
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 610
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I've seen brackets for other sizes of fans to replace the annoyingly loud 40mm stock fan, but none for a 92mm x 15mm fan that I happened to have lying around. I tried to keep the design as clean and simple as possible. Since the fan itself isn't too heavy, the bracket does not need to be too thick. I kept my design at 2mm thick, with 3mm for the vertical legs, and made use of some of the internal vertical bracing in the bottom compartment to provide additional support.
You will need to use taller feet for your printer to provide enough clearance below for the fan.
I reused two of the original screws that mounted the metal cover at the edge of the base. You will need:
- 2x M3 6mm screws
- 2x M3 T-slot nuts (for mounting the vertical legs to the aluminum extrusion
- 4x M3 20mm screws for the fan
- 4x M3 nuts
If you are using a 12V fan, then you'll also need to wire a 24V to 12V buck converter. The 2-pin connector to the mainboard is a JST 2.54mm.
The 92mm fan is probably way overkill for the mainboard. Consider that the stock 40mm fan spins at 5500 RPM and puts out a maximum of 7.7 CFM, while the 92mm fan outputs nearly 30CFM at 2200 RPM and is much more quiet. I'll likely turn the speed down even more so that it's nearly inaudible yet it will still cool things better than the stock fan.