Bosch dishwasher water softener salt funnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Funnel your salt into the water softener tank like a boss!
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 243
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
Here's a very simple and crude funnel that fits the opening of the salt tank of both older and newer Bosch dishwashers. The older funnel had 4 legs that went into the tank to hold the funnel in place, newer variants seem different. This model mimics the principle of the first type, but simply matches the 3 slots in the opening and is held in place somewhat loosely by its taper.
The model is completely solid, and requires vase mode (named "spiralise outer contour" in some slicers) and some other settings during slicing. In addition, the line width is increased and bottom layers removed.
The settings below worked for me with a 0.4 mm nozzle and Creality Hyper PLA. Print speed is 33minutes, weight 19g.
| Layer height | 0.3 mm |
| Line width | 0.6 mm |
| Initial bottom layers | 0 |
| Wall speed | 60 mm/s, or as high as you dare.. |
| Minimum layer time | 5 seconds or lower, to speed up printing |
| Adhesion | Brim |
| Spiralise outer contour / vase mode | Enable |