Garmin Zumo 590LM Replacement Power Button
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If the rubber power button failed then you can use this plastic 3d printed one to replace it. It will not be waterproof
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 108
- Wydruki
- 0
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Simple replacement for original.
I have tested this in PETG.
It might work better in TPU to help improve water-resistance.
Also you may want to shorten it by 2mm or 3mm so it doesn't get accidentally bumped as easily.
You must disassemble the Garmin to install this from the inside. You will need a Torx #5 and a Phillips #0. There is also a delicate ribbon cable.
If the rubber of the Zumo housing is very old and brittle, some will likely crack and flake off but that should only be cosmetic.
Caution, after installing this, it will be very easy to push-down hard on the electronic button on the circuit board and in extreme cases you might even crush the electronic button.
Idea for a remix: add a 1.5mm bump on the botton of this button to limit the travel and protect the electronic button.