1 / 3
PTFE tube (re)director for Sunlu S2 dryer 0.1 — zdjęcie 1
1 / 3

PTFE tube (re)director for Sunlu S2 dryer 0.1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bends PTFE tube to be placed at a better angle

Ocena
5 / 5
Polubienia
3
Pobrania
23
Wydruki
1
Wyświetlenia
185
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

By default PTFE tube is connected perpendicular to the spool, in case of TPU that caused issues for me, filament didn't move freely.

Installation:

  1. Remove screws (see second picture)
  2. Remove the original PTFE ring from the hole
  3. Place the printed part as shown on the pictures
  4. Put screws back but don't tighten them too hard, there's going to be a 1-2mm gap now. Could be fixed with better model tuning.
  5. Insert PTFE tube

Tagi