TronXY X5S Direct Drive Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printed on the X5S before switching to a direct drive setup.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 485
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed on the X5S before switching to a direct drive setup.
You'll want to re-orient the models for better printability. The guide should be printed as an "L" shape, looking down onto the bed. The spool-holder-bracket should be printed with the longest flat side down on the bed and the shorter side, which is mounted to the t-slot, will rise straight up off the bed.
The spool holder needs no new hardware, simply remove the existing bowdin spool holder and re-use the bolts and t-nuts.
Slice a 2mm piece of the bowdin PTFE tube off and put it in the filament guide.
I'm using this with:
Titan Extrude
Titan Extruder Pancake Motor
Volcano Heater Block
For the fan shroud, I did not use a magnet, I just drilled a 3mm hole and used a 3mm bolt to hold it on.
Print instructions
Category: 3D Printer Parts Print Settings
Rafts: No
Supports: No
Resolution: .8mm nozzle, .4mm layer heights (but you can use any)
Infill: 25-65%, I used 25%
If you find this model useful, consider supporting my work: https://ko-fi.com/natester