1 / 3
Vevor Mini Metal Lathe Chuck Key Wrench Holder — zdjęcie 1
1 / 3

Vevor Mini Metal Lathe Chuck Key Wrench Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Easy to get to storage place for the chuck key.

Ocena
0 / 5
Polubienia
11
Pobrania
53
Wydruki
0
Wyświetlenia
232
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

As a retired machinist most lathes I ran had some type of chuck key holder, always metal, that someone made. I wanted one for this home lathe to prevent it from getting misplaced. It uses the same screws that hold the gear cover plate minus the washers. I made the holder to go as far over as I could to clear the back shaft hole. If you run material outside the back hole I would suggest removing the key. Even a small diameter rod could sling to the edge of the hole when running and hit the key.

I used standard PLA setting except for 4 walls and 25% infill. The best matching color was by Duramic 3D, Electric Blue from Amazon.

Tagi