1 / 6
Anycubic Kobra 3 fan duct inproved 3 Ways
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an improvement of the Kobra 3 fan duct
- Ocena
- 5 / 5
- Polubienia
- 112
- Pobrania
- 1152
- Wydruki
- 3
- Wyświetlenia
- 3432
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 3) (Komentarze: 11)Remiksy (1)Kolekcje (123)Powiązane
The original Kobra 3 duct did not properly cool the front and rear of the models, causing failures when we have overhangs or very pronounced angles in these parts. This is my first iteration of the original duct. A front outlet was added, and the side outlets were lengthened by 7mm, to improve ventilation in the back of the models.
Recommending printing it in ABS, PETG, or ASA, and printing it at a 45 degree angle as shown in the laminator image.
no supports required