Volvo 740 / 940 Turbo Air Filter Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A encapsulated cold air filtered intake, utilizing the hole found stock in the Volvo 940 Turbo.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 615
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Another Volvo 940 Turbo part.
I wanted a more high flowing air filter, that also sucks in cold air and is "shielded" from the warm air in the engine bay.
So I came up with this tube design, that utilizes the stock hole that is not utilized by the stock air filter box.
It grabs cold air from the inside of the fender.
It is made up of both 3D printed parts and Alu tubes. But could be 3D printed fully as well.
The filter material is something I have access to from work, and is just a mesh fabric.
The outer dimension of the hose fitting is the same as a stock size MAF sensor housing, 70mm. And should have a hose to connect it to the MAF sensor.
Materials needed;
- 6 pieces of M6 threaded rods, 190mm long.
- 6 hex nuts, preferably locking ones.
- 6 Wing nuts, or other hand tightening nuts.
- 1 piece of 125x170x4mm ALU tube, if not 3D printed.
- 1 piece of 100x103x2mm ALU tube, if not 3D printed.
- 1 piece of 100x62x2mm ALU tube, if not 3D printed.
- Mesh fabric to act as the filter material.
- Metal Mesh sheet, to prevent large debris to enter the filter
These are my recommended settings for print strength;
Material: Basically anything except for PLA
Walls: 8
Top/Bottom: 8
Infill: 35% Gyroid
Support: Normal(auto), style “Snug” (If using OrcaSlicer)
Wall Generator: Arachne (Nozzle size has a wider wall thickness range)
Alternate extra wall (Stronger wall to infill bond)
Walls Printing Order: Inner/Outer/Inner (A quality boost in walls visual and mechanical accuracy)
Seam: Scarf Joint Contour & Hole (In theory should proved with a stronger seam, better accuracy)
Print at a higher temp than usual, if you are printing 220°C, try 230°C. To make the filament bond better. Should not present any defects like overhangs drooping.
If you can't raise your temps without issues, then slow down your printing. Will not work as good, but it does improve the bonding between the layers more than running it fast, use as little fan as possible if using for instance PLA. None at all preferably.
Initial Release - 2025-04-16;
Not yet tested, will print it and update if needed.
2025-04-17;
Added cutouts for the threaded rods
2025-04-18;
Extended hose fitting on each side, also included fasteners in 3D model
2025-05-09;
Uploaded new version, with a clamping support bracket. As well as a .f3z file for Fusion 360 users