Vixen Dovetail riser mount for SeeStar S50 and Sky Watcher EQ Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Vixen Style dovetail mount to raise the SeeStar S50 up above the dovetail retaining knob on the Sky Watcher EQ Base.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 194
- Wydruki
- 4
- Wyświetlenia
- 1184
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
When mounting a SeeStar S50 to the Sky-Watcher EQ base, the knob to tighten the dovetail block to the EQ mount will not fit because it hits the bottom of the S50.
Many videos show using a long bolt to move the knob out from under the S50, bu that just seem like a bad hack to me.
This is a vixen style dovetail mount with a built in riser to give room under the S50 for the retaining screw knob.
It uses the tripod screw from the Sky-Watcher dovetail mount, and is designed to allow the use of a US quarter to tighten the screw into the S50 tripod mount. It also has a small divot where the dovetail side bolt hits to secure it to the EQ base.
I also tightened up the tolerances because the included dovetail mount seemed to have a very loose fit on the base.
There is a 3mf file included in case you want to play with the model.
I printed it in ABS and added a modifier to make the area around where the tripod screw goes and where the side screw interfaces with it 100% infill.
Print with the flat down, and it does not require any supports.