1 / 2
Vixen Dovetail riser mount for SeeStar S50 and Sky Watcher EQ Base — image 1
1 / 2

Vixen Dovetail riser mount for SeeStar S50 and Sky Watcher EQ Base

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A Vixen Style dovetail mount to raise the SeeStar S50 up above the dovetail retaining knob on the Sky Watcher EQ Base.

Rating
5 / 5
Likes
17
Downloads
192
Makes
4
Views
1,167
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

When mounting a SeeStar S50 to the Sky-Watcher EQ base, the knob to tighten the dovetail block to the EQ mount will not fit because it hits the bottom of the S50.

Many videos show using a long bolt to move the knob out from under the S50, bu that just seem like a bad hack to me.

This is a vixen style dovetail mount with a built in riser to give room under the S50 for the retaining screw knob.

It uses the tripod screw from the Sky-Watcher dovetail mount, and is designed to allow the use of a US quarter to tighten the screw into the S50 tripod mount.  It also has a small divot where the dovetail side bolt hits to secure it to the EQ base.

I also tightened up the tolerances because the included dovetail mount seemed to have a very loose fit on the base.

There is a 3mf file included in case you want to play with the model.

I printed it in ABS and added a modifier to make the area around where the tripod screw goes and where the side screw interfaces with it 100% infill.

Print with the flat down, and it does not require any supports.

Tags