DeskPi Pro V2.0 front - back cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Complete redesign of the front and back cover for more functionality.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 231
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Before you download my 3D print, please check the dimensions with your DeskPi Pro V2.0 case twice. I can't answer whether the cover also fits the DeskPi Pro V3.0 case ... I don't have one.
Front cover dimensions:
Length: 149.50mm
Width: 35.80mm
Height: 3.00mm
HotPlug holder dimensions:
Diameter/radius: 4.00mm
Height: 0.50mm
Slot ribbon cable dimensions:
Length: 19.887mm
Width: 1.20mm
Back cover dimensions:
Length: 149.50mm
Width: 35.80mm
Height: 3,00mm
Dimensions of back cover hole for WiFi or 2pin connector:
Length: 8,650mm
Width: 7,150mm
After I only found 3d prints that didn't fit and were just bad, I went to a lot of trouble and created a new 3d print template from scratch!
Also worth mentioning:
Unfortunately, the manufacturers from the "DeskPi Team" and "SeedStudio" were not very cooperative and did not provide me with any 3D print templates. By the way, the same housing is used in the SensCAP M1 Miner.
Front panel modifications:
- air slots doubled - right outside
- slot for ribbon cable (e.g. camera) - between the air slots
- SSD HotPlug slot, screws unnecessary - above the USB ports
- SSD HotPlug holder - was attached to the SSD with an adhesive strip
Rear panel modifications:
- slots for airflow outlet changed - top left
- hole for external WLAN antenna or 2pin hole (fan connector) - above the LAN port