patafix Klebenagel / blu tack adhesive nail / round and straight version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Neuinterpretation eines Klebenagels für patafix / reinterpretation of an adhesive nail for blu tack
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 82
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- GNU General Public License v3.0
Dies ist ein konzeptioneller Nachbau des kommerziell verfügbaren "Klebenagel" von der Marke mit dem kleinen t. In die sechs Einbuchtungen auf der Rückseite passt jeweils genau ein 10mm * 13mm Stückchen weißes patafix. Drückt man die Rückseite an eine glatte Fläche, quillt diese Menge genau in die Kammer und wird fast nur noch auf Scherung belastet.
Druck den “Nagel” ruhig liegend mit Support für alle Flächen über 50° Neigung. Der Haken ist mit 45° ohne support druckbar und die “schlechte” Oberfläche über dem Support in den Einbuchtungen sorgt dafür, dass das patafix sich zwischen das Filament presst und sich nicht vom Druckteil lösen kann. Sieht man sehr schön auf dem Bild am Ende.
---
This is a conceptual reproduction of the commercially available "Adhesive Nail" from the brand with the small t. Each of the six recesses on the back fits exactly one 10mm * 13mm piece of white patafix. When you press the back against a smooth surface, this amount squeezes perfectly into the chamber and is almost exclusively subjected to shear stress.
Print the "nail" in a flat position with support for all surfaces with an inclination over 50°. The hook can be printed at 45° without support, and the "rough" surface above the support in the recesses ensures that the patafix / blu tack squeezes between the filament and cannot detach from the printed part. See image below for that.
---
