AI-Thinker ESP32 CAM cam mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
AI-Thinker ESP32 CAM mount for Prusa MK4 or MK4S
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This model can use the same extension arm as the original model, or the extended one by Gerald, but is for the AI-Thinker version of the ESP32 CAM board. Hole in the back over the 5V+GND pins to power the module, fits a 2-pin Dupont connector, or you can just solder the wires. PRO TIP - use a piece of double sided thermal tape to attach the camera sensor module to the SD-Card slot. The metal of the SD-Card slot will then act as heatsink for the sensor. It can get very hot and cause blurry images or even camera failure. You need four M2.5 screws for assembly. The camera needs to be in an upright position to clear the build plate for the initial layers - not like in the photo.