Fit & Anti-Slip Ring (TPU) | Remix of Food Bowl Riser by Eski
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Supports bowls narrower than the original model 135mm diameter bowl size.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
After printing the Food Bowl Riser model by Eski, I found my bowls were a bit small and just dropped through. Rather than trash a perfectly good riser, I thought this would be a good opportunity to create an adapter for smaller bowls.
The ring is printed in TPU (0.00mm fit tolerance with the original model). The inner diameter is narrowed by 10mm supporting bowls down to 125mm. The ring slopes inward following the original model.
My risers were printed on a QIDI Plus4 using PLA at 0.24mm Draft quality with supports.
The light melamine bowls fit snuggly, do no slip, and lift out easily.