Pavo 20 Pro Runcam Wifilink 2 Canopy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a runcam wifilink 2 canopy for my pavo 20 pro, so i modeled this...
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 523
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pavo 20 Pro Runcam Wifilink 2 Canopy
This is a custom-modeled canopy for the Pavo 20 Pro, designed to fit a Runcam Wifilink 2.
Printing Recommendations:
Material: PETG or PLA
Infill: Minimum 15% Gyroid
Layer Height: Maximum 0.2mm
Supports: Tree supports are recommended, using the default file orientation.
Available Versions
V1: The standard, original model.
V2: A lighter version with a GoPro-style mount and an 14mm GPS mount.
V2.5: Even lighter and stronger than V2, with an improved design that fixes the fan mount's breaking issue.
V3: Same as V2.5, but with 18mm GPS mount.
Installation Guide
You will need new, shorter antennas to install this canopy; I used the GEPRC Peano antenna.
Connect the new antennas to your Runcam Wifilink 2 and place them in the designated spots on the canopy.
Gently bend the canopy to fit the Runcam Wifilink 2 into place.
Use the small screws that came with your Pavo 20 Pro to secure the Runcam Wifilink 2 to the canopy.
Next, use the screws from the Runcam Wifilink 2 to mount the camera. Make sure the camera's cable is facing up.
Tuck all cables neatly into the protective channels inside the canopy.